Touch In DAT

From TouchDesigner 099 Wiki

Summary

The Touch In DAT receives full tables across the network from the Touch Out DAT, as opposed to messages with the other network based DATs.

See also UDP Out DAT.

Parameters - Touch In Page

Protocol protocol - Select which protocol to use, refer to the Network Protocols article for more information.

Network Address address - For multi-cast protocol, this is the multi-cast address to listen for. For UDT protocol this is the IP address of the server.

Port port - The port receiving the packets.

Shared Connection shared - Use the same connection as other networking DATs using the same network protocol.

Active active - While on, the DAT receives information sent to the network port. While Off, no updating occurs. Data sent to the port is lost.