UDT In DAT
The UDT In DAT is used for receiving information over a UDT connection between two remotely located computers. It captures all the messages without any queuing or buffering, and allows you to send it any messages you want. UDT Streaming is a reliable, streaming, connection orientated protocol. A single server can send to multiple clients at the same time.
Handle received messages using the callback DAT attached to the UDT In DAT. Send replies using the udtinDAT_Class.
Parameters - Connect Page
protocol - Select which protocol to use, refer to the Network Protocols article for more information.
address - You can put an IP address to listen on (220.127.116.11). This parameter is only needed for multicast protocols.
port - The network port the listen on.
format - determines how the incoming data is parsed into the table.
- One Row Per Byte - One row is added to the table per byte received.
- One Row Per Line - One row is added to the table per line received.
- One Row Per Message - One row is added to the table per message received.
script - This check box enables the connection.
Parameters - Received Messages Page
script - the Script DAT will execute once for each message coming in. See udtinDAT_Class for usage.
executeloc - Determines the location the script is run from.
- Current Node
current- The script is executed from the current node location (for example, where 'cc' points to).
- Script DAT
script- The script is executed from the location of the DAT specified in the Script DAT parameter.
- Specified Operator
op- The script is executed from the operator specified in the From Operator parameter below.
fromop - The operator whose state change will trigger the DAT to execute its script when Execute is set to Specified Operator. This operator is also the path that the script will be executed from if the Execute From parameter is set to Specified Operator.
clamp - The DAT is limited to 100 messages by default but with Clamp Output, this can be set to anything including unlimited.
maxlines - Limits the number of messages, older messages are removed from the list first.
clear - Deletes all lines except the heading. To clear with a python script
Keep First Row
firstrow - Keeps first row in table.
bytes - Outputs the raw bytes of the message in a separate column.