Hello,
Not the most experienced user here but having a little trouble getting my Point Grey FL3-USB3.1 camera working properly.
The Spinnaker SDK seems to be working well, as does my USB chipset. When I launch the application "Spinview" the device shows up on the USB interface and I receive and process 120hz.
If I launch Touch Designer and enable a "video" TOP and select the Spinnaker library the following happens :
* Capture is limited to 60fps in both Touch Designer and Spinview.
This only happens once Touch Designer and the "video" top has been activated.
* If I inspect with a CHOP info I can see that half of the frames are being dropped.
The info chop also reports capture fps at 60_fps
* Even if I decrease the image format to 640x480 these symptoms persist
On the "videodevicein" top the "options" tab is greyed out. I assume this is normal when selecting the Spinnaker library? Any ideas are appreciated.