Hi All,
im a little stuck here. id like to have a container be controlled by dmx. ive built a working circuit but cant figure something out. I would like to do 2 things. when i run a container through a replicator id like it to map to the next set of open channels with a pre defined block. second id like to be able to set the starting Channel. any Ideas? just trying to take out some of the long tedious work of manually entering every channel in each container. so essentially id like each container to be a fixture on my board.
Edit:
I tried using me.parent().digits +3 but all that did was give me was “1+3=4” and i would like to to be “1 2 3 4” in my select top.
also cant figure out how to have it reference the mast used start channel so that my 2nd panel does not start on the second address of panel 1