RESOLVED:"Skipping unrecognized parameter" 088 64-bit 62070

So I’ve been working on this for a little bit and then I come back the next day to open the file and I get a bunch of “Skipping unrecognized parameter” warnings. Any clue what it might be? I was using the “menuSource” field in some customize components dialogs, but those parameters are actually fine, just a bunch of other ones in the file got messed up. That was my only guess.


fixture to DMX Worksheet.toe (6.84 KB)

These errors are often caused by either opening a .toe file in an eariler build than it was saved, ie. going from 099 back to 088, or build 62070 back to 61700 which is not recommended.

The other time it can occur is if you Change OP Type on a component. For example I see a lot of errors on square_to_dmx COMP, perhaps that one you changed from a Base to a Container or something? In these cases usually re-saving the .toe again will clean it up.