Flag

From TouchDesigner 099 Wiki
(Redirected from Flags)

The term "flag" in TouchDesigner refers to the indicator of states of an Operator (the Bypass, Display, Lock flags etc).

Operator Flags

Operator flags are located around a node in a network pane and/or in a network's "table" view (press "t" in the network to toggle).

When you press "t" in a network pane, it shows nodes in a table format, where the complete set of flags is visible on the columns.

Flags are not parameters and therefore changing a flag does not in itself cause a node to cook. You cannot export to a flag.

All flags are displayed and set using the opset command.

Flag states are retrieved with the opflag() expression.

Flags on all Nodes

Flags on 3D Object components

  • Render - if off, the object will not be seen in any render of the Render TOP or Render Pass TOP.
  • Display - if off, the object will not be seen in any camera viewer.
  • Pickable - if off, the object will not be selectable in 3D Geometry Viewers or the SOP Editor.

Flags on CHOPs

  • Export - if off, nothing is exported from that CHOP.

Flags on SOPs

  • Compare - displays the SOP's input geometry as a green wireframe for comparisons.
  • Template - displays the SOP as templated geometry in 3D viewers. The grey wireframe template is not selectable or editable.