Page 1 of 1

Combine multi-screen kantan mapper and container controls?

PostPosted: Fri May 17, 2019 3:24 pm
by gltd
I have a three projector setup where I plan to route all textures through Kantan Mapper. I have Kantan Mapper set to "Bounds of All Monitors". (I've read in a few places that this is the most performant strategy.)

I need to also include a simple interface with buttons that toggle between a few settings.

I seem to be asking google the wrong questions about how to share screen space during performance mode between a simple interface and Kantan Mapper.

Could someone point me in the right direction? Thank you!

Re: Combine multi-screen kantan mapper and container control

PostPosted: Mon May 20, 2019 1:07 am
by ajk48n
Quick answer is that kantan should only be outputting on your projectors. You would make a separate panel for your interface that will be used on the laptop/desktop. Then that panel along with the kantan panels are combined into one big window that spans the desktop plus all projectors

Re: Combine multi-screen kantan mapper and container control

PostPosted: Mon May 20, 2019 3:07 pm
by gltd
Thank you for spelling this out for me!