Enttec dmx usb pro

[kinglevel]

Wow that was fast. Nice to hear.
You can try reducing the 'queue size' in the DMX In CHOP to see if that helps with the latency.
It may produce slightly jaggier ramps though.
We still need to address buffering and smoothing of the data in future releases.

Make sure you're using the default 'FTDI Serial' interface on both DMX In + Out,
and not 'Generic Serial'.

Cheers,
Rob.

ah ok!
About the artnet setting, there is now way of set any IP settings?
Im no big artnet user, but i think there should be a setting for ip adresses

[rob]

Hi.
From what I understand the ip address is derived from the Universe/Net/Subnet addresses parameters, which you can modify.
The CHOP simply broadcasts messages with this address encoded in the message.